| Specifications︰ | Rated heat input: 20KW, 24KW, 32KW
Rated hot water capacity: 10, 12, 16L/min (25 centigrade)
Gas type: LPG, NG
Gas pressure: 2800 Pa, 2000 Pa
Ignition type: water control pulse ignition
Exhaust type: force exhaust type or balance type
Applicable water pressure: 0.01- 0.80 MPa
Min. water flow to start: 2.50L/min
Rate voltage: a.c 220V/50Hz or 110V/60Hz
|
|
|
Microcomputer controls the constant temperature. The temperature ranges within 32-80. Fixed temperature limits in 2 centigrade.
Full automatic digital display controls;
High efficient and energy saving combustion system;
Intelligent alarm system
The low-noise high-speed blower fan is used to discharge the smoke to the outside and take in the outdoor air for combustion.
Adequate combustion to save energy:
Low water pressure startup（≥0.015MPa）;
LCD digital display of water temperature
Pilot safety device: in case of accidental shut off of water heater, sensing device will automatically cut off gas supply;
Draft switch protection device: in case of blocked flue or too high wind pressure, gas supply will be automatically cut off to avoid influence on normal operation of water heater due to unpunctual exhaust of waste gas;
Overheating protection： when outgoing water temperature is overrun 90 degrees centigrade, gas supply will be automatically cut off. The pre-cleaning program can be used to clear off all the waste gas to prevent outburst. The post-cleaning program may be used to exhaust all the remaining heat and waste gas to ensure security
Ignition delay device: avoid outburst upon ignition;
Electric leakage protection： the electric leakage switch will prevent leakage and ensure safety.
|
|
|
|
|
